Fasten the timer to the wall box using the screws provided. Be sure the TOP (indicated on yoke of timer) is facing up. Insert timer into the 2 1/2" wall box, being careful not to pinch any wires.NOTE: Be sure that all wires and wire nuts are secure. Tug each wire to verify connection, retighten if needed.Add the neutral wire to all neutral wires bound together and retighten the wire nut, making sure that the wire nut is tight. There may be several neutral wires bound together. Often the neutral wire (white) can be found in the back of the wire box connected with a wire nut. Connect the neutral wire from the timer to the neutral wire in the box.Insert and tighten jumper wire into the hole marked NEUTRAL. Remove white jumper wire from the package.Attach ground wire from box to the ground lug on the timer. ![]() Insert the load side wire from the wire box into hole marked LOAD and tighten the LOAD screw.Insert the line side wire from the wire box into hole marked LINE and tighten the LINE screw.When loosening terminal screws, stop when you feel resistance. Loosen the LINE and LOAD screws with either a flat-blade or Phillips screwdriver.Look at the back of the timer and you will see LINE, LOAD, NEUTRAL and GROUND. Remove current wallplate and switch from wall box.Turn power off at circuit breaker or fuse box before installation.If you are unsure about the installation of this timer please contact a licensed electrician. User manual In-Wall Digital Timer for MyTouchSmart 26893 Requires a neutral wire for installation.MyTouchSmart 26893 24-Hour in-Wall Digital Timer - Use Manual - Use Guide PDF. Electrical Ratings: 120 vac, 60Hz, 15a resistive, 10a tungsten, 5a electronic ballast, 1/2 HP motor, UL listed.Backup battery maintains your settings in the event of a power outage. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |